Polishing Ring
Polishing ring soft
POLRG-SOFT-(F.EPM200-E)-D200MM
Register now and access more than 20,000 products
- Up to three times higher material removal power with shorter processing times
- Lower coating weight for easier handling
- Less contact pressure necessary, resulting in less fatigue
- Cost savings due to markedly lower paste consumption compared with conventional cloth discs
- Streak-free working due to the continuously changing surface structure and the piled folding
- The polishing rings are made of a purely mechanically bonded, innovative and flexible matted fleece specially developed for high-gloss polishing
- 10-ply
Apply the paste with the machine running!
Datasheets(X)
For high-gloss polishing or buffing of almost all polishable materials in conjunction with buffing paste
Materials to be processed: Steel, stainless steel, non-ferrous metals and plastic parts and coatings
The better the pre-sanding, the simpler and shorter the effort required for polishing. Metals should be pre-sanded with 280 or 320 grain abrasive cloth.
Every work step should be crosswise or diagonal to the previous one.
Important: If the individual work steps are not carried out carefully, flaws in the surface become even more obvious during buffing.
A separate set of polishing rings should be used for each paste. This prevents mixing of different pastes and impairment of the result.
Clean clogged polishing rings by gently pressing with a wire brush.
Remove polishing residues on the surface with brake cleaner.
The application recommendations have a general character depending on how good the initial surface is or how high the requirements for the final surface are.
Recommended working speed: approximately 25 m/s. (corresponds to stages 4–6 for PM 200-E).
The correct procedure and speed must be determined on a case-by-case basis.
Perform preliminary testing or conduct your own tests!
Diameter (Ø) | 200 mm |
Suitable for stainless steel | Yes |
Suitable for steel | Yes |
Suitable for non-ferrous metals | Yes |
Last viewed
2-CUTTER SDS-PLUS HAMMER DRILL BITS Red Stripe
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, A2-70 stainless steel
Hexalobular-type cheese head screw, low head
Tensioning washer For screw connections DIN 6796, spring steel C60, mechanically applied zinc coating
Vehicle dry sandpaper disc Arizona® Perfect
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, A2-70 stainless steel
C 6.3 PH bit (1/4 inch)
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, A2-70 stainless steel
Ring bolt DIN 580, material: C15 E, zinc-plated steel, blue passivated (A2K)
Twist drill bits HSS DIN 338 type RN TIN head